How to Clean HEPA Filter, Dust Cup & Cyclone Unit [V750]
1. Push "Dust Cup Release Button" to take off Dust Cup from Vacuum Cleaner.
2. Take off the Cyclone Unit and HEPAFilter from the Dust Cup.
3. Firmly tap the HEPA filter to shake off the dust lodged in its tiny pores and restore proper airflow.
4. Do not wash the HEPA filter with water, as this may cause clogging and reduce suction performance.
5. Use scissors to cut and remove hair entangled on the Cyclone Unit.
6. Please note that the steel mesh around the Cyclone Unit may be surrounded by dust buildup, which can block airflow and reduce suction performance.
7. Wash the Dust Cup and Cyclone Unit by water.
8. Air dry the dust cup and Cyclone Unit.
Note: Do not expose the Cyclone Unit to the sun.
9. Install Cyclone Unit and HEPA Filter into the Dust Cup.
10. Install Dust Cup onto Vacuum Cleaner.
Note:
Make sure to place the Back-Flow Prevention Rubber inside the Dust Cup.
If it is not installed correctly, debris may fall out easily, and the vacuum will not be able to draw debris into the Dust Cup properly.
— THE END —
Disclaimer: This article expresses the will of the release at the time, and if there is any misunderstanding, the final interpretation right belongs to Tikom.
